Radio Shack PRO-76 - Using the Display Backlight

31
channel for activity every 2
seconds.
PRI
appears
whenever the scanner is set
to use priority.
The scanner automatically
designates each bank’s first
channel as its priority chan-
nel. Follow these steps to
select a different channel as
the priority channel for a
bank.
1. Press
PROG
.
2. Enter the channel num-
ber you want to select as
the priority channel, then
press
PRI
.
P
appears to
the right of the channel
number.
3. Repeat Step 2 for the
channel in each bank
you want to program as
a priority channel.
To turn on the priority fea-
ture, press
PRI
while
MAN
or
SCAN
appear.
PRI
appears.
As you scan the bank, the
scanner checks the bank’s
priority channel every 2 sec-
onds in each bank that is
turned on, starting from the
lowest to the highest-
numbered priority channel.
To turn off the priority fea-
ture, press
PRI
.
PRI
disap-
pears.
Notes:
• You cannot select a
monitor memory when
priority is turned on.
• You can lock out priority
channels. If you lock out
all priority channels,
P
CH
LOC Out
appears
when you turn on the pri-
ority feature.
USING THE
DISPLAY
BACKLIGHT
You can turn on the display’s
backlight for easy viewing in
the dark. Press to turn on
the display light for 15 sec-
onds. To turn off the light
sooner, press again.
Note:
The scanner locks the
keypad (see “Using the Key-
Lock” on Page 28) if you
hold down . If this hap-
pens, hold down until the
scanner beeps (if the key
tone is turned on) and
KEY-
LOCK
disappears.
20-313.fm Page 31 Friday, January 7, 2000 3:09 PM