42
Scanner is on
but will not
scan
(continued)
Only one channel is
(or no channels
are) stored.
Store frequencies into more
than one channel.
The scanner is not
set to scan.
Press
SCAN
.
All channels are
locked out.
Make sure at least two
channels are not locked out.
During scan-
ning, the scan-
ner locks on
frequencies
that have an
unclear trans-
mission.
Programmed fre-
quencies are the
same as “birdie”
frequencies.
Avoid programming fre-
quencies listed under
“Birdie Frequencies” on
Page 34, or only listen to
them manually.
SQUELCH
might
not be set properly.
Be sure
SQUELCH
is ad-
justed properly. See “Turn-
ing On the Scanner/Setting
Volume and Squelch” on
Page 22.
PROBLEM POSSIBLE CAUSE SOLUTION
20-313.fm Page 42 Friday, January 7, 2000 3:09 PM
To Next Page
Loading...
