37
1. Press
PGM, and then TRUNK.
2. Press
FUNC, and then S or T
to select the desired bank.
3. Press
FUNC, and then press
8. Block 0 size code. Use 15 for
type II. S-00
is displayed.
4. Enter the size code supplied
with the Type I system
information, referring to the
prompts that appear in the
display. If the information for
your Type I system is not
available, try the following
common fleet maps:
Ô
Ô
NOTES Ô
• The default setting of
thebankisfor
Motorola Type II.
However, if you set
Type I and wish to
restoreTypeII,enter
15 at Step 4.
• Toconfirmtheinput,
repeat Steps 1-4 and
press ENTER.Each
time you press
ENTER,youconfirm
thesizecode.Ifyou
find an error, press
CLR and begin again
at Step 1.
Block Size Code
123 4 5 6 7 8
0 S11 S4 S4 S12 S4 S3 S10 S1
1 S11 S4 S4 — S4 S10 S10 S1
2 S11 S4 S4 S4 S12 S4 S11 S2
3 S11 S4 S4 S4 — S4 S4 S2
4 S11 S4 S4 S4 S4 S12 S4 S3
5 S11 S4 S4 S4 S4 — S4 S3
6 S11 S4 S12 S4 S4 S12 S4 S4
7 S11 S4 — S4 S4 — S4 S4
Block Size Code
91011 12 13141516
0 S4 S0 S4 S0 S3 S4 S4 S3
1 S4S0S0S0S3S3S4S10
2 S0 S0 S0 S0 S11 S10 S4 S10
3 S0S0S0S0S4S4S11S11
4 S0 S0 S0 S0 S4 S4 S11 S0
5 S0S0S0S0S0S4S0S0
To Next Page
Loading...
