80
While the folder is being
cleared, the scanner will
display
This display appears after each V-
Scanner operation. Pressing
ENTER will return to the main V-
Scanner menu. Press
CLR to exit
the V-Scanner main menu.
This display appears if a failure is
encountered while performing a V-
Scanner operation. Press
ENTER
to try again.
Ifyouwishtocreateanew
configuration based on your
current one, save the current
working memory to a V-Scanner
folder, then edit the working
memory with your changes. When
you are finished with your edits,
save your updated working
memory to a new V-Scanner
folder, leaving the V-Scanner
folder with your original
configuration intact. You may then
use either your original
configuration or the modified one.
Be sure to assign a name to each
V-Scanner before you save it to a
V-Scanner folder. You assign a V-
Scanner name while using the
configuration in working memory
by pressing
PGM, and then FUNC,
TEXT. The text you enter here is
stored in line 4 of the welcome
message and saved with the
contents of the V-Scanner when
youwriteittoafolder.
You can use the V-Scanner
feature to back up your work. Save
your configuration to a V-Scanner
folder after you make changes to a
learing
-Scanner: 1
lease Wait
V-Scanner
Operation
Complete
Press ENTER
V-Scanner
Operation
Failure
Press ENTER
To Next Page
Loading...
