37
There are two ways you can
program your scanner to operate
with CTCSS. If you know the
CTCSS code that is used on a
particular frequency, you can
manually enter the code when you
are programming the scanner, or
any time afterwards.
You can also set a special search
code up that will instantly decode
the CTCSS code on a received
transmission. Channels
programmed with the search code
will receive all traffic on the
channel, and will instantly decode
and display any CTCSS code that
is found with the transmission.
You can then store the found code
in the channel memory with one
keystroke.
Programming a Quiet
Code into a Channel
1. Select the channel you want
to program the quiet code.Ô
2. Press
FUNC, and then press
<.
Set Tone Code appears.
3. Press
^
or v to select quiet
code (frequency). See the
“Quiet Code Chart” on
Page 37.
4. Press
ENT to set the quiet
code.
Quiet Code Chart
Ô NOTES Ô
• If you want to
program a quiet code
into a car number
frequency, you can
select the car number
frequency.
• The scanner might
detect an adjoining
quiet code and
sometimes receive
the frequency.
Code Frequency (Hz) Code Frequency (Hz)
00 SRCH 20 131.8
01 67.0 21 136.5
02 71.9 22 141.3
03 74.4 23 146.2
20-515Change01_04.fm Page 37 Friday, January 16, 2004 1:14 PM
To Next Page
Loading...
