Radio Shack Telephone Interface II Operation Guide

I ENTER I for the next menu entry in the "MENU ENTRY" column. In this
situation, the screen might look like this:
6. When <<<PLEASE WAIT>>> is displayed on the screen, the computer
saves the option list program you have created onto the Network 3 software
diskette
in Drive 0, under the filename you specified in Step 3 above. When
saving is complete,
the screen displays ''DONE''.
To run this option list program at the Student Stations, follow these steps:
1. Set up the Network 3 Controller, Host system, and Student Stations. Run
the HOST program and load in the Student Station System Software
program by following Steps 1 through 15 beginning on page 3.
2. At the Host system, the Network 3 software diskette (which now also
contains
the menu program you have created) should be in Drive 0 (the
bottom disk drive). Place the diskette containing all the programs listed in
the menu program in Drive 1 (the top disk drive).
3.
At each Student Station that will use the option list you have created, type
[BJ [[] [ID [:] ~ [BJ [Q] rn ~ ~ 00 • I ENTER 1. (In this example, the filename
"CHOICES" is used. Be sure to use the filename of the option list program
you created.)
4. The program will now display the list of descriptive names you entered when
you
set up the option list. (The list of corresponding filenames will not
appear.) The student can choose the desired option by typing the number
that appears next to that option. The option list program will automatically
run the lesson program the student has chosen.
5. To
return to the option list, terminate the current lesson program and start
again at Step 3.
13

Radio Shack Telephone Interface II Specifications

General

Brand	Radio Shack
Model	Telephone Interface II
Category	Desktop
Language	English