Radio Shack Telephone Interface II Operation Guide

To erase the menu program you created, place the Network 3 software diskette
(which contains your menu program) in Drive 0 and press the orange Reset button.
When "TRSDOS Ready" is displayed, type [K] [I] [b] [b] 0 ~ [HJ [QJ [I]~ lg][[) (or
whatever filename you assigned your menu) and press I ENTER L When "TRSDOS
Ready"
reappears, your menu program is erased.
Using MAILBOX with the Network 3
MAILBOX is a demonstration BASIC program contained on the Network 3
software
diskette which is designed to illustrate the operation of the Network 3. It
allows students to send messages to one another from Student Stations. The
messages are
stored on the Network 3 software diskette at the Host computer.
Follow
these steps to use MAILBOX:
1. Set up the Network 3 Controller, Host system, and Student Station s. Run
the HOST program and load in the Student Station System Software
program by following Steps 1 through 15 beginning on page 3.
2. At each Student Station that is to participate, type [ID [ID [A] [[I [I] ~ and
press I ENTER I; then type [BJ [ID [ID [:] [M] [A] [I] [b] [ID [Q] [X] [:] I ENTER ! .
From this point on, the program guides the student through its use. A total of 25
student messages can be stored by the program.
The teacher
can leave a "bulletin board" message (a message that will be seen by
all the students using the program) by selecting option 1 and typing
(A] [L] [L] I ENTER l in response to the question, ''WHO DO YOU WANT TO SEND IT
TO?"
(Unlike other messages, these bulletin board messages cannot be erased by
the student.)
The teacher
can erase a bulletin board message by choosing option 2, typing
(A] [L] [L] I ENTER I. and then typing [y] when Erase? appears on the screen.
To erase all messages:
(1) choose option 1, (2) hold down the !SHIFT! key while
pressing ~, and ( 3) press I ENTER l.
14

Radio Shack Telephone Interface II Specifications

General

Brand	Radio Shack
Model	Telephone Interface II
Category	Desktop
Language	English