Radio Shack Telephone Interface II Operation Guide

10. When "Ready" reappears, the program is loaded into the computer. To make
sure, you can type [b] I] [ID [I] I ENTER ! . and the program lines should be
displayed on the screen. You are now ready to save the program onto
diskette. (If you should want to save the program onto a diskette other
than the Net work 3 software diskette now in Drive 0, insert the diskette on
which you
want to save the program into Drive 1.)
11. The filename ADDITION is used in this example; you use the actual
filename of the program that you want stored on the diskette.
Note: Be sure to use a different filename for each program you save onto
the diskette. Each filename must contain from one to eight letters and
numbers, and the first character in each filename must be a letter. Do not
use the filenames HOST /CMD, STUDENT /CMD, or SPOOL /TXT, as these
filenames are already used on the diskette.
When the screen reads:
Ready
You type:
[ID [A] [y] ~ CJ [A] [Q] [Q] [I] [!] [I] [QJ (fil [:]
!ENTER!
(Note: If you want to save the
program on a formatted or system
diskette in Drive 1, you should type
[ID [A] [y] ~ CJ [A] [Q] [Q] [I] [I] [I] [Q] [[] [] [I] [:]
!ENTER!
instead of _ the above.)
12.
If you are saving programs on the Network 3 software diskette and the
screen displays "Disk full", follow Steps B through E beginning on page 21.
Place
your new backup copy of the Network 3 software diskette in Drive 0
(the
bottom drive) and press the orange Reset button. When "TRSDOS
Ready"
appear s on the screen, type [BJ [Q] [I] [TI I ENTER L When " Baud
rate? '' appears, press I ENTER I. Then go back to the Student Station and
continue with Step 11 above.
13.
If you are saving programs on Drive 1 and the screen reads "Disk full ",
follow Step B on page 21. Place another formatted or system diskette in
Drive 1 ( the top drive). Go back to the Student Sta tion and continue with
Step 11 abov e.
If you ha ve tran sferred all the program s you want to run, you are finished when
the red light on the disk dri ve goes off. Your programs are now stored on this
diskette. Be sure this diskette is in the Host computer when you want your
st nd P.n t.s t.o rnn t.h P.SP, progr ~ rn ~.
If you wan t to tran sfer additional program s from a ca sse tt e to your diskette, repeat
Steps 4 through 13 above.
18

Radio Shack Telephone Interface II Specifications

General

Brand	Radio Shack
Model	Telephone Interface II
Category	Desktop
Language	English