Radio Shack Telephone Interface II Operation Guide

If the asterisks appear, but the right one does not blink:
•
press the I BREAK I key on the computer
• press the STOP button on the recorder
•
turn the volume on the recorder a little lower
•
repeat Steps 12 and 13 above and then continue from Step 18 above.
20. When
"Ready'' reappears on the screen, the program is loaded into the
computer. You are now ready to save it onto the Network 3 software
diskette. The filename ADDITION is used in this example; you use the
actual filename of the program that you want stored on the diskette.
Note: Be sure to use a different filename for each program you save onto
the diskette. Each filename must contain from one to eight letters and
numbers, and the first character in each filename must be a letter . Do not
use the filenames HOST /CMD, STUDENT /CMD, or SPOOL/TXT, as these
filenames are already used on the diskette.
When the screen reads:
Ready
You type:
[[I 00 00 [[] ~ lAHID [ID [I] [TI [I] [QJ [NJ CJ
!ENTER!
21. If the screen displays "Disk full", follow Steps A through E beginning on
page 21. Press the STOP button on the tape recorder. Repeat Steps 11
through 13 above. Place your new backup copy of the Network 3 software
diskette in the disk drive and close the drive door. Continue with Step 16
above.
If you have transferred all the programs you want to run, you are finished when
the red light on the disk drive goes off. Your programs are now stored on this copy
of
the Network 3 software diskette. Use this diskette when you want your students
to run these programs.
If there are additional programs you want to transfer to the Network 3 software
diskette, continue from Step 3 above.
25

Radio Shack Telephone Interface II Specifications

General

Brand	Radio Shack
Model	Telephone Interface II
Category	Desktop
Language	English