EasyManuals Logo

Radio Shack Telephone Interface II Operation Guide

Radio Shack Telephone Interface II
54 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #5 background imageLoading...
Page #5 background image
Recorder
Model
User-Generated
Pre-Recorded
Tapes
Radio
Shack
Tapes
CTR-80,
CTR-BOA
5-7
4-6
Recommended
Volume
Settings
for
Radio
Shack
Cassette
Decks
When
Used
with
TRS-80
Model
Ill
(With the CTR-40, CTR-80, and CTR-80A, tum the control to the left to
increase volume. With the CTR-41, tum the control to the right.)
When information is being loaded from the cassette tape, two asterisks will
appear on the screen. The one on the right will flash on or
off
as the program is
read in.
If
the asterisks do not appear,
or
the one on the right does not flash,
then the volume setting is probably too low. Increase the volume and
try again.
If
you have a Model III this may be an indication that the tape's baud rate is dif-
ferent than the Computer's baud rate. (All Radio Shack Model I Level II pre-
recorded cassettes are recorded at 500 baud rate, so Low baud rate must be
selected when they are loaded on the Model III.) Try resetting the baud rate
from high to low
or
vice versa (See your Operation Manual).
Use the reset button to stop the cassette and return control to you
if
loading
problems occur.
Radio Shack programs are recorded at least twice on each tape. Following this
practice when you record programs on tape will give you a back-up
if
one does
not load properly
or
if
it becomes damaged.
Important
Note:
The CTR-41 requires that you keep the supplied
''
dummy
plug"
in the MIC
jack
at all times. However, the other models should never be
used with the
''dummy
plug.''
Level
I
Sometimes you will get an error message during an attempted
CL0AD
. This
means that some information was lost
or
garbled. Adjust the volume level
slightly and try again.
Level
II (Also
Model
ill
BASIC)
In case
of
an error message, proceed as above. In Level II, there is also a rare
case in which the program is not loaded correctly even though no error message
is generated. So, after
CLOADing
a program, be sure to LIST it.
If
some data was
garbled, then at some point in the listing the display will be filled with meaning-
less words and characters. Adjust the volume and
try again.
Hints
and
Tips
Computer tapes should be stored in a relatively dust-free area (a cassette case is
recommended) and protected from high temperatures. Magnetic and electrical
fields may alter recorded information, so avoid placing the tape near them

Other manuals for Radio Shack Telephone Interface II

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Radio Shack Telephone Interface II and is the answer not in the manual?

Radio Shack Telephone Interface II Specifications

General IconGeneral
BrandRadio Shack
ModelTelephone Interface II
CategoryDesktop
LanguageEnglish

Related product manuals