Radio Shack TRS-80 DWP-210 - 2; Setting Up the DWP-210; Print Wheel Installation and Removal

2/ Setting
Up the DWP-210
When setting up the DWP-2
10,
be sure you select
a level,
sturdy location
with
plenty of
room for easy paper flow.
Print Wheel
Installation/Removal
The
DWP-2
1 package includes
a Courier 1 Print
Wheel which
you
will need
to
install before
printing. If
you
wish,
you may purchase
from
Radio
Shack a
1 2 pitch
and/or
Proportional
Spaced Print
Wheel for different
printing
operation.
Check
with your local
Radio
Shack
Computer Center
or
store since
we are
con-
tinually making
more font
styles
available.
To
install
the Print
Wheel
1
.
Open the
Front Cover.
2. Remove
the
Ribbon Cartridge
(If it
is installed).
3. Pull
the Wheel
Lock Lever
in the
direction
indicated
by the
arrow
(see Figure
6A).
The
wheel Holder
will
then
open.
4. Drop the
Print Wheel
into its
Holder. (Be
sure the
type characters
are facing
the
paper.)
5
.
Gently
push the Lock Lever
in the
direction
indicated
by
the
arrow until
it locks
into place
(see Figure
6B).
The
Wheel
is set in
position
and ready
to
print.
Figure
6A
Figure
6B
To
remove the Print
Wheel:
1
.
Remove the
Ribbon Cartridge.
2. Press the Wheel Lock Lever
as described above
(see Figure
6
A).
3. Remove
the Print Wheel (see Figure
6B).
Note: Replace the
Print Wheel
when
any
"petal" is
broken
or
bent
or when it
becomes unusable for
any reason.