Appendix
A/
Using the DWP-210
with
the TRS-80 Model II
To use the DWP-210 with
SCRIPSIT, type
(at TRSDOS READY):
PATCH
SCRIPSIT/SYS (R=175
B=22
F=0F
C=FF) <ENTER>
You will also have
to adjust
the
character width
and
the
backspace distance.
See the SCRIPSIT
2.0
reference manual for details.
Instead of the above
procedure, users of SCRIPSIT
2.1 can use
the
PRTPCH
program provided with it. Answer the
prompts for
the
DWP-410 (this is code-
compatible with the DWP-2
1
0).
TRSDOS-II Users:
To
use SCRIPSIT, type
(at
TRSDOS-II Ready):
DODWP410<ENTER>
Several PATCH COMPLETE message will
appear. To remove these patches so
that you can
use
other printers,
type:
DO UNDWP410 <ENTER>
Note:
If
you are using
TRSDOS-II
on a hard disk system,
you will
need
to
insert
your SCRIPSIT
installation diskette into Drive
before doing the above patches.
21
To Next Page
Loading...