Paper
Loading
You
can use
either
fanfold computer paper
(up to
1
3"
wide) or single-sheet
typewriter paper
with the DWP-2 10.
If
you use
fanfold paper, you'll probably
want
to
also use the DWP-2 10
Bidirectional Tractor Feed (26-1443,
optional/
extra)
for efficient printing. For instructions on
loading and using the Tractor
Feed, see its operator
manual. When using
single-sheet paper, you
must
disable
the Paper Empty
Detect Function by
closing DIP Switch No.
3
(see "DIP Switch
Setup").
Otherwise, the
Printer will remain in a paper empty
state, and will not
start printing. When using a
continuous form fanfold paper, be sure DIP
Switch
No. 3 is
open.
1
.
Open the Front Cover.
2.
Pull the Paper Bail
Lever toward you to
raise the Paper
Bail.
3.
Push the
Platen Pressure Lever away
from you to apply
pressure.
4. Insert the paper
with
its
left edge along the Paper Guide.
5. Turn
the Platen Knob to advance the
paper
past
the Paper Guide.
6. Then the paper comes out in
front of the Platen, pull the Platen Pressure Lever
toward you to release
pressure.
7.
Align and position the paper at
the left margin.
8.
Push the Platen
Pressure Lever away from you to apply
pressure.
9.
Return the Paper Bail Lever to its
original position.
10.
Turn the Platen Knob to position the paper to
the first line of printing.
See next
section.
Figure
8. Paper Loading
To Next Page
Loading...