Radio Shack TRS-80 DWP-210 - Page 5

OPERATION
MANUAL
TOP
PAD
MASKING
TAPE
PG
STOPPER
SILENCE
COVER
PAD
PRINT
WHEEL
SILENCE COVER
CARRIAGE
STOPPER\
PAPER
GUIDE
SERIAL
INTERFACE
CONNECTOR
UUl'UUUUU
UUUUU13UU
PLEASE READ USER'S MANUAL BEFORE
USE.
ACCESSORIES
ARE IN
THE TOP
PAD.
UNPACKING PROCEDURES FOR DWP-210
1.
REMOVE THE TOP PAD
AND
TS ANGLES.
(POWER
SUPPLY CORD,
PRINT
WHEEL, AND RIBBON
CASSETTE
ARE
INSIDE OF THE TOP PAD.)
2.
HOLD THE
BOTTOM OF
THE PRINTER
WITH
BOTH
HANDS
AND
CAREFULLY
AND
SLOWLY REMOVE
FROM
THE
OUTER
CARTON.
CAUTION: PLEASE, DO NOT HOLD THE KNOBS OR THE
CUSHION FORMS
WHEN
DRAWING
OUT THE
PRINTER.
3.
REMOVE THREE
PIECES
OF
MASKING TAPE ON
THE SILENCE
COVER,
THE SILENCE COVER
PAD.
4.
AFTER OPENING THE
SILENCE COVER, REMOVE
THE CARRIAGE
STOPPER
(2PCS.) THE PG
STOPPER
AND THE PWH
STOPPER
BETWEEN THE
PW
SET LEVER
AND THE
RIBBON
BASE.
5.
INSTALL
THE
PRINT WHEEL AND
THE
RIBBON
CASSETTE.
6.
TURN
THE SILENCE
COVER
TOWARD YOU.
PWH STOPPER
POWER
SUPPLY
CONNECTOR