-MODEL
II
OPERATION
3 / Operation
1.
Be
sure all drives in the System are empty, and all
components
are
turned
off.
If
no Disk Expansion
System is
present,
be sure to connect the Disk
Terminator
plug to
the
Computer.
2.
Turn
on
the
Computer
(Display Console). Wait until
the
message
"INSERT
DISKEITE"
appears
on
the
display.
Ifthe
message fails to
appear
within
10
seconds, press
RESET.
If
it stilI fails to appear, turn
the
Computer
off
and
check all connections. Wait at
least
15
seconds
before
starting over at step
1.
3.
When
"INSERT
DISKETTE"
is
displayed, turn on
the
Disk
Expansion
System (if connected) and all
other
peripherals.
4.
Insert
the
System diskette into drive 0
and
close the
drive
door.
The
Computer
will load the operating
system
and
prompt
you to
enter
the
date
and time.
5.
Before
turning
the
Computer
off, remove
alI
diskettes
from alI drives.
Then
turn off the entire
system.
6.
After
any
power-down, wait at least
15
seconds
before
turning
the
System
on
again. Start at step
1.
Using the RESET Switch
If
you
should
ever
lose
Keyboard
control
of
theSystem,
or
you simply
want
to
re-initialize, press
RESET
up momentarily
and
release it.
The
Computer
will
repeat
the
power-up
sequence,
but
the contents
of
user memory will
not
be
affected.
Note:
You
do
not
need
to remove the diskette during this
Reset
sequence.
10
To Next Page
Loading...
Need help?
General
