ENGLISHDEUTSCHESpAñoLFRANÇAISITALIANoNEDERLANDS
5
Batteries should be disposed of in accordance with your company’s work practice, and/
or any relevant laws or guidelines in your country.
This instrument, or family of instruments, will not be permanently damaged by
reasonable electrostatic discharge and has been tested in accordance with IEC 801-2.
However, in extreme cases temporary malfunction may occur. If this happens, switch off,
wait and switch on again. If the instrument still malfunctions, disconnect the batteries for
ve seconds and then reinstall and switch the unit on.
WARNING! The RD8000 will detect almost all buried conductors but there are
some objects that do not radiate any detectable signal. The RD8000, or any other
electromagnetic locator, cannot detect these objects so proceed with caution.
There are also some live cables which the RD8000 will not be able to detect in
Power mode. The RD8000 does not indicate whether a signal is from a single
cable or from several in close proximity.
Wireless technology compliance
Use of iLOC™ wireless technology may be subject to national telecommunication
regulations. Check with your local government authorities for further information.
FCC and Industry Canada statements
This device complies with part 15 of the FCC Rules. Operation is subject to the following
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired
operation.
Changes or modications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment. To comply with the
FCC RD explore compliance requirements, this device and its antenna must not be co-
located or operated in conjunction with any other antenna or transmitter.
Training
Radiodetection provides training services for most Radiodetection products. Our
qualied instructors will train equipment operators or other personnel at your preferred
location or at Radiodetection headquarters. For more information go to
www.radiodetection.com or contact your local Radiodetection representative.
Service and Maintenance
The receiver and transmitter are designed so that they do not require regular calibration.
However, as with all safety equipment, it is recommended that they are serviced at least
once a year either at Radiodetection or an approved repair center.
Radiodetection products, including this user guide, are under continuous development
and are subject to change without notice. Go to www.radiodetection.com or contact
your local Radiodetection representative for the latest information regarding the RD8000
or any Radiodetection product.
To Next Page
Loading...
Need help?
General
