Need help?Do you have a question about the Radionics D6500 and is the answer not in the manual?
Configures the J3 jumper on the MPU Terminator Card for different communication modes.
Selects programming options within the D6500 MPU program to affect output.
Details additional crucial MPU program options for device operation.
Details message types (Type 1 and Type 3) and their structure in D6500 mode.
Explains messages transmitted in SIA format, including header and data structure.
Lists messages displayed on internal/external printers or computer terminals.
Describes how to send commands to the D6500 for time/date setting and line card switching.
Explains the process of testing the connection between the D6500 and automation system.
Configures the RS-232 data I/O protocols for the external device connected to the D6555.
Lists reports from the external printer and internal printer module for comparison.
Lists Contact-ID event codes for various alarm types.
Lists Contact-ID event codes for system troubles.
Lists Contact-ID event codes for sounder/relay issues.
Lists Contact-ID event codes for system and peripheral problems.
Lists Contact-ID event codes for communication failures.
Lists Contact-ID event codes for protection loop issues.
Lists Contact-ID event codes for sensor problems.
Lists Contact-ID event codes related to remote access.
Lists Contact-ID event codes for remote access events.
Lists Contact-ID event codes for access control events.
Lists Contact-ID event codes for disables and bypasses.
Lists Contact-ID event codes for tests and miscellaneous events.
To Next Page
General