To connect the quick-release insulated hoses to the
hose tidies, push the PEEK coupling on the hose
onto the protruding lug of the hose tidy.
A slight twisting motion while pushing the fitting
may aid this process.
Once the coupling is fully engaged on the lug, screw
the red Rodaviss screw cap located onto the hose
connector and hand-tighten.
Never operate the system with a thermoregulator running whilst hoses are attached to the hose
tidies. Hose tidies are a convenient storage device for hoses not connected to a vessel (for
example, when changing or cleaning the vessel). They are not intended to provide a leakproof
seal for a system fully charged with thermofluid.
To Next Page
Loading...
