49
3. To set the time
Pull the crown out to position 3 and turn
it forwards or backwards (Caliber 657*
forwards only) to the desired time. Accept by
pushing the crown back to position 1 to
coincide with a given time signal.
**Rotating bezel
On certain models the rotating bezel is lo-
cated under the protective covering of the
sapphire crystal and can be manipulated
with the crown.
Short time measurement
Unscrew the crown. Turn the crown to move
the 60-minute marker to the position of the
minute hand. Screw the crown back in
place. The elapsed time can subsequently
be read off on the inner rotating bezel.
THE CROWN HAS 3 POSITIONS
1. Normal position
The crown is in its normal position if it is
pressed up against the case (position 1)
or screwed in. In this position, the crown
ensures that the watch is water-resistant
(if not damaged).
2. To set the date
Pull the crown out to position 2, turn it for-
wards or backwards (depending on the
movement, Caliber 657* forwards only) to
set the desired date. Push the crown back
to position 1.
NOTE: Date setting is not recommended
between 8 pm and 2 am.
To Next Page
Loading...
