53
Chronograph functions
with split-seconds
The split-seconds function allows split
times to be recorded while the chronograph
is running.
1. Start the chronograph by pressing
pusher A.
2. To record a split time, press pusher C.
The split-seconds hand stops, indicating the
split time, while the chronograph continues
running.
NOTE: The split time should be read imme-
diately, since the chronograph totalizers
for hours, minutes and seconds continue
to measure the elapsed time.
While the chronograph is running, do not
leave the split-seconds hand stopped any
longer than is necessary to read the split
time, otherwise the functioning of the split-
seconds mechanism may be affected.
3. Press pusher C for the split-seconds hand
to catch up with the chronograph seconds
hand.
4. To record a new split time, start from
step 2 above.
5. Press pusher A to stop the chronograph.
6. Press pusher B to reset.
IMPORTANT: The split-seconds hand must
have caught up with the chronograph sec-
onds hand, as explained in step 3 above,
before the chronograph is reset.
To Next Page
Loading...
