RADWAG PS 6100 R2

- 88 -
IC0_OK CR LF
- command carried out
Operation is disabled for verified balances.
Give balance serial number
Format: NB CR LF
Response options:
NB_A_”x” CR LF
- command understood, response: serial number
NB_I CR LF
- command understood but not accessible at this moment
x – serial number of the device (inserted in between inverted commas)
An example:
Command:
NB CR LF – return serial number
Response:
NB_A_”1234567” – serial number of the device – ”1234567”
Lock balance keypad
Format: K1 CR LF
Response options:
K1_I CR LF
- command understood but not accessible at this moment
K1_OK CR LF
- command carried out
Command locks the balance keypad (proximity sensors, touch panel) until the moment of turning the
balance off or until sending K0 command
Unlock balance keypad
Format: K0 CR LF
Response options:
K0_I CR LF
- command understood but not accessible at this moment
K0_OK CR LF
- command carried out
Give available working modes
Command overview: Command returns accessible working modes.
Format: OMI CR LF
Response options:
OMI CR LF
n_”Nazwa modu” CR LF:
n_”Nazwa modu” CR LF
OK CR LF
–
command carried out, response: accessible working modes
OMI_I CR LF
– command understood but not accessible at this moment
Mode name – parameter, working mode name, inserted in between inverted comas. The name takes
form given on a particular balance display, it is provided in a currently selected language.
n – parameter, decimal value determining working mode number.
n →
1 – Weighing
2
– Parts Counting
3
– Deviations
4
– Dosing
5
– Formulas
6
– Animal Weighing
8
– Solids Density
9
– Liquids Density
10
– Peak Hold
11
– Totalizing
12
– Checkweighing
13 – Statistics
CAUTION! Working modes numbering is identical for each kind of balance. The numbers are assigned to
working modes names. Some balances give only the number as a response.
An example 1:
Command:
OMI CR LF
– return accessible working modes
Response:
OMI CR LF
2_”
Parts counting” CR LF
4_”
Dosing” CR LF
12_”Checkweighing” CR LF
–
accessible working modes are given in
return:
mode number + name
OK CR LF
– command carried out