To Next PageTo Next PageWhat to do if my RADWAG Scales are not turning on?
If your RADWAG Scales are not turning on, it might be due to discharged batteries. Try connecting the device to the mains or changing the batteries. Another possible cause is missing or improperly installed batteries. In this case, check the correct installation and polarization of the batteries.
What to do if after turning on RADWAG WTB Scales I see the message 'LH' on the display?
If you see the message 'LH' on the display of your RADWAG Scales after turning it on, it means that the weight pan was loaded during power up. Unload the pan, and the scale should then indicate zero.
General| Model | WTB series |
|---|---|
| Readability [d] | 0.001 g / 0.01 g / 0.1 g / 1 g (depending on model) |
| Stabilization time | ≤ 3 seconds |
| Adjustment | External |
| Display | LCD (backlit) |
| Material | Stainless steel |
| Interface | RS232 |
WTB scales use NiMH batteries; device monitors and charges batteries.
Adjusting the filter level (1-4) to suit ambient conditions and improve stability.
Step-by-step process for adjusting the scale's calibration factors.
List of commands for controlling the scale and retrieving data.
