What to do if my RADWAG Scales won't turn on?
If your RADWAG Scales do not turn on, the cause may be discharged batteries or no batteries (not installed or improperly installed). Connect the device to mains or change the batteries. Also, check the correctness of the battery installation, paying attention to the correct polarization.
Why do RADWAG WPT turn off automatically?
If your RADWAG Scales turn off automatically, it could be because the 't1' setting is set to 'YES' which activates the power save mode. To resolve this, go to the 'othr' submenu and change the '5.4 t1' setting to 'no'.
What to do if RADWAG WPT display 'LH' after turning on?
If your RADWAG Scales display the message 'LH' after turning on, it means the weight pan was loaded during the powering up. Unload the pan, and the scale will then indicate zero.
Details on battery types, charging, and replacement for scale operation.
Procedure for setting tare weight to determine net mass of a load.
Process for zeroing the scale to ensure accurate measurements.
Using the scale for counting small identical items.
Setting upper and lower thresholds for mass deviation control.
Monitoring percentage deviation against a standard mass.
Procedure for fast net mass determination using automatic tare.
Function for summing up multiple weighings.
Specific procedure for weighing live animals.
Procedure for calibrating the scale for accurate measurements.
Adjusting the scale's initial mass setting without full calibration.
Technical specifications for various WPT series scales.
Technical specifications for WPT/F series table scales.
Technical specifications for WPT/H series waterproof scales.
Technical specifications for WPT/HR series waterproof scales.
To Next Page
General
