• Turn the pillar and mount it to
the platform. The surplus cable
place inside the pillar.
• Pick up the pan and remove
the transport protection.
6. GETTING STARTED
• After unpacking and mounting the scale level it out.
Use levelling legs and the level condition
indicator installed in the basis of the scale.
• Turn the device on using the
key – keep pressing the key
for about 0.5 sec,
• Wait for the test completion,
• Then you will see zero indication and pictograms:
- zero indication
- stable result
kg - weight unit
• If the indication is not zero press zero key.
- 19 -
To Next Page
Loading...
Need help?
General
