* automatic enabling/disabling according to the source of power.
Procedure:
• Enter the submenu <P5.othr> and then:
Returnto weighing:
See 10.2.2.
14.4. Battery voltage level check
While supplying from batteries too low level of voltage is measured
by software the pictogram
is displayed. It means that charging
or exchanging batteries is required.
14.4.1. Checking the batteries
This function is to check the level of battery supply. It works only if:
• Weighing mode is set,
• Battery supply is set in parameters.
- 40 -
To Next Page
Loading...
