57ESP-LX+ & LXi+ Installation, Programming, & Operation Guide
➌ If you wish to bring the power supply wires through the
wall on which you mount the controller, use the ½"
(1,3cm) knockout in the rear of the cabinet. Also remove
the circular cutout in the flame-retardant fiberboard liner
at the rear of the high-voltage compartment. For safety
purposes, be sure to seal the unused entry at the bottom
of the cabinet.
➍ If you wish to bring the supply wires through the bottom of
the cabinet, attach a ½" (1,3cm) conduit fitting to the
bottom entrance of the high-voltage compartment. Then
attach conduit to the fitting.
To Next Page
