39ESP-LX+ & LXi+ Installation, Programming, & Operation Guide
Press the MAN START/ADV button to begin the RASTER.
➎ The display shows TEST IO, and the FAULT Indicator
light flashes once as the RASTER confirms the proper
operation of the controllers front panel lights.
The RASTER then automatically checks the controllers
master valve and each station valve (in numerical order).
NOTE: If the front panel ribbon cable is not connected
to the circuit board or the controller is disconnected
from the main power supply, the LCD will display the
message NO OUT.
TEST IO
To Next Page
Loading...
Need help?
General
