Raisecom Technology Co., Ltd
58
Channel:Main Channel
Local Loopback:Loopback Remote Loopback:No Loopback
Error Code Test:Disable
7235 Auto Adjust Phase:Enable
Adjust Receive Phase:Enable(Clock Down)
DTR State:1(Unready) RTS State:1(Unready)
DCD State:0(Ready) CTS State:0(Ready)
Note: parameters of phase adjustment: positive and negative;
Channel: main channel & Single channel
Loopback Set: No Loopback & Loopback
Error Code Test: Disable & Enable
Auto to Adjust Phase for Transmit: Enalbe & Disable
To Adjust Receive Phase: Enable & Disable
Status of DTR, RTS, DCD, CTS: Ready & Unready
Error Test Effect: Normal & Abnormal; if you disble error code test,
there will not be this item.
User-board type 7 V24 data user card:
Not available now
User-board type 8 Ethernet data user card:
Type: 8 Ether Net Board Channel Number: 8 Set Mode:Software
Signal:None
Channel:Main Channel
Band Width Buffer:>256Kbps
Defeat Link Default Set:Half Duplex
Link State:Link Down
FXD State:Half Duplex
Note: Band Width Buffer is used to adjust buffer to reduce latency.
User-board type 9 RS232 serial interface user card:
Type: 9 RS232 Board Channel Number: 8 Set Mode:Hardware
Signal:None
Band Width:64Kbps
Device Query Command:1-8, Menu Display:M, Return:Q Command:
Note: the bandwidth configuration is not effective now
User-board type 10 RS422 serial interface user card:
User-Board 3:
Type:10 RS422 Board Channel Number: 8 Set
Mode:Hardware
Signal:Exist
Band Width:64Kbps
Device Query Command:1-8, Menu Display:M, Return:Q Command:
Note: the bandwidth configuration is not effective now
User-board type 11 magneto telephone card:
Type:11 Magneto Board Channel Number: 8 Set Mode:Hardware
To Next Page
Loading...
Need help?
General
