SECTION 2 - GUIDE RAILS AND CROSS BRACES.
Page 2-4
Rev 1A – Oct. 2003
2.4
a.) Slide the next (upper or mid) guide rail sections in
place. Insert all of the outside bolts. Remove the
uppermost inner guide rail bolt (do not remove all
the inner guide rail bolts or the connector tube will
fall inside the guide rail).
b.) Put the 6 hole cross brace in place at an angle
(Fig. 4) and insert one bolt on each side as shown.
Remove the lower inside bolt, swing the cross
brace into position and install the remaining bolts.
Leave all bolts loose.
NOTE: Do not use washers for the bolt heads on the
outside of the guide rails.
Figure 4. Installing the middle cross brace, looking
from in front of the guide rails.
NOTE:
MATERIAL LIST PART #
1. 7/16 x 2 bolt
2. 7/16 x 2 ¼ bolt
3. 7/16 Flat washer
4. 6 hole crossbrace FFBUG006
To Next Page
Loading...