To Next Page

To Previous Page

Accel/Decel

To Increase Speed

When the Electronic Speed Control is set, you can increase speed by tapping the

Speed Control lever up (+).

The drivers preferred units can be selected through the radio settings if equipped.

Refer to ”Uconnect

Settings” in “Understanding Your Instrument Panel” on the

DVD for more information. The speed increment shown is dependant on the chosen

speed unit of U.S. (mph) or Metric (km/h):

U.S. Speed (mph)

• Tapping the Speed Control lever up (+) once will result in a 1 mph increase in set

speed. Each subsequent tap of the lever results in an increase of 1 mph.

• If the lever is continually held up, the set speed will continue to increase until the

lever is released, then the new set speed will be established.

Metric Speed (km/h)

• Tapping the Speed Control lever up (+) once will result in a 1 km/h increase in set

speed. Each subsequent tap of the lever results in an increase of 1 km/h.

• If the lever is continually held up, the set speed will continue to increase until the

lever is released, then the new set speed will be established.

To Decrease Speed

When the Electronic Speed Control is set, you can decrease speed by tapping the

Speed Control lever down (-).

The drivers preferred units can be selected through the radio settings if equipped.

Refer to ”Uconnect

Settings” in “Understanding Your Instrument Panel” on the

DVD for more information. The speed increment shown is dependant on the chosen

speed unit of U.S. (mph) or Metric (km/h):

U.S. Speed (mph)

• Tapping the Speed Control lever down (-) once will result in a 1 mph decrease in

set speed. Each subsequent tap of the lever results in a decrease of 1 mph.

• If the lever is continually held down, the set speed will continue to decrease until

the lever is released, then the new set speed will be established.

Metric Speed (km/h)

• Tapping the Speed Control lever down (-) once will result in a 1 km/h decrease in

set speed. Each subsequent tap of the lever results in a decrease of 1 km/h.

• If the lever is continually held down, the set speed will continue to decrease until

the lever is released, then the new set speed will be established.

Resume

• To resume a previously set speed, push the RES button and release.

OPERATING YOUR VEHICLE

RAM ProMaster2015 User Manual

Questions and Answers: