Uconnect® RH3
Enable Or Disable Clock
1. Push the DISP button for more than two seconds to enable or disable the Clock.
2. When this function is enabled, the display shows the message "CLK ON" and the
clock is displayed whenever the ignition is On, even with the radio Off. In
10 seconds if no radio key is pushed, the display returns to the clock.
3. When this function is disabled, the message "CLK OFF" is displayed on the radio
display.
NOTE:
This procedure sets the time on the radio clock ONLY. To set the time in the
Electronic Vehicle Information Center, please refer to the section titled Electronic
Vehicle Information Center (EVIC) in this manual.
Uconnect® RH3
1 — On/Off Volume Knob
2 — Display
3 — SEEK Down Button
4 — Mute/Pause Button
5 — SEEK Up Button
6 — Source Button
7 — Menu Button
8 — RND Button
9 — Display Button
10 — Band/As Button
11 — Preset Buttons
12 — Audio Button
13 — Fast Track Button
ELECTRONICS
33
To Next Page
Loading...
Need help?
General
