TRAKFAST REPAIR MANUAL
16
Rev. 09/07
TOOL DISASSEMBLY
REMOVE MOTOR ASSEMBLY
Pull Handle Assembly away from Motor Assembly until fan clears
combustion chamber assembly.
Do not scratch combustion chamber walls with fan blades.
Set Handle Assembly down carefully so that Fan Blades are not
damaged and Fan Motor Shaft is not bent.
When removing handle from housing, be sure not to bend fan
blades.
Be sure leads and connectors are positioned so that leads are not
pinched when installing cap.
WARNING
DO NOT operate tool until all screws are tightened.
DANGER
NEVER attempt to operate tool without cap assembly securely
fastened. Cap assembly secures cylinder head to combustion
chamber.
Operating TrakFast with cap assembly off or loose will cause burn-
ing fuel to escape through top of tool, causing burns and damage
to tool.
CAUTION
To Next Page
Loading...