TRAKFAST REPAIR MANUAL
46
Rev. 09/07
TOOL REASSEMBLY
Handle Assembly - part 2
Place plastic wire cover over wires.
Make sure all wires are seated properly in handle.vva
Place Trigger Switch on top of the wire cover.
Secure with screws.
Check for any damage.
Press button to make sure it is not sticking.
Plug into Spark Unit.
Check all wires for damage.
Place wire in Handle away from screw holes.
Place Wire Cover over Spark Plug Wire and P.C. Board wires.
Place Cylinder Head on top of Wire Cover and secure with screw.
To Next Page
Loading...