RAMSET TRAKFAST - PREPARING TOOL FOR OPERATION - TOOL PROBLEMS

TRAKFAST REPAIR MANUAL
62
Rev. 09/07
TROUBLESHOOTING GUIDE
SYMPTOM POSSIBLE PROBLEMS SERVICE
Fasteners do not slide freely into
Magazine; strip does not advance into
nose of tool.
Pin or pins not properly collated. Use strip with proper collation.
Damaged strip. Discard the damaged strip
Burr(s) in Shear Block Replace Shear Block
Follower does not engage the strip
properly; Follower snaps forward when
released, bypassing strip.
Follower spring broken, missing or
improperly installed.
Install new Constant Force Spring.
Follower defective. Replace Follower
Follower carrier does not advance. Damaged Constant Force Spring Replace Constant Force Spring.
Improper assembly of Lockout
Bracket.
Check for proper assembly.
Battery Clip does not latch securely. Battery Clip broken or distorted. Replace Battery Clip.
PREPARING TOOL FOR OPERATION — TOOL PROBLEMS