Ramtech WES3 - Troubleshooting; Led Codes

12
TROUBLE SHOOTING
1
LED CODES
Description Flash Type
Group Flash 1 - Low Battery
Group Flash 2 - Low signal
Group Flash 3 - Unpaired
Group Flash 4 - Tamper
Group Flash 5 - Re-arm or Unit latched (potentially
input latched on Interface unit only)
Green LED Active units with no faults will ash their green LEDs once every
4 seconds to indicate that the unit is operational.
Amber LED Each WES3 unit monitors itself for a number of faults. These are
indicated via the amber LED, which will ash in grouped patterns with longer
than usual gaps in between them.
Units displaying one of these patterns require further investigation and should
not be relied upon as part of the evacuation alarm and detection system
until the fault has been corrected. Use the chart on page 13 to determine the
nature of the issue.
Red LED If a Sensor triggers the alarm, its red LED indicator will ash during
an alarm. If a sensor has raised the alarm, its red LED indicator will ash during
an alarm.
WES3 Base Station | RAMTECHGLOBAL.COM/WES/
It is recommended that the system is tested weekly or whenever a signicant change
has been made to the installation or the building under construction.