Ramtech WES3 - Resetting a Call Point; Raising a Medical Alert; Cancelling a Medical Alert

14
3
UNIT SOUNDS
Sound Issue: Call Point unit periodically beeping after an alarm has
been reset
The Call Point is latched and needs to be manually reset using the key
provided.
Sound Issue: WES3 Base Station beeps frequently
System warning. If alarm has been raised, LCD screen will display ‘ALARM
ALARM ALARM’ together with details of which unit has raised the alarm.
If another warning is given, check the warning code against the warning code
table on page 13.
4
SILENCING THE ALARM
The alarm must be silenced either by using the reset key or on the WES3 Base
Station unit.
The alarm will automatically silence 30 minutes after activation. The
evacuation alarm can be manually cancelled from a Call Point that has been
pressed using the reset key provided. If necessary, a Call Point on a nearby call
point can be pressed and then reset to cancel the alarm.
Please wait for 5 seconds between pressing and resetting a Call Point. After the
alarm has cleared the system has a short (2 minute) re-arm period during which
the sirens will sound intermittently, and the amber warning LEDs ash in groups
of 5, following which the system is re-armed and ready for use.
During the re-arm period, the alarm cannot be reactivated. It is therefore vital
to conrm that there is no hazard before silencing the alarm.
WES3 Base Station | RAMTECHGLOBAL.COM/WES/
Note: It is vital to conrm that there is no hazard before silencing the alarm. Do not
attempt to open the unit or deactivate by removing the battery.