Ramtech WES3 - Initial Setup

4
SETTING UP WES3
Installing WES3 on your site is easy. You will need to start by activate / powering
on each unit and add the units to the group so that they can communicate
with each other.
1
INITIAL SETUP
STEP 1 Activate and power on
To activate/power on the WES3 Base Station unit, hold down ‘A’ and press
‘B’ three times in quick succession. All three LEDs will illuminate and then the
amber LED will ash.
Initial setup of the WES3 Base Station is through a series of on-screen options.
Language, Inspection Delay and Pre-Alarm mode options can be congured.
STEP 2 Language selection
Select language - the available options are English, German, French, Spanish,
Italian and Swedish. Language settings can be changed at any time.
STEP 3 Set inspection delay
The Inspection Delay setting allows an optional delay period between
triggering a Call Point and the site wide alarm being raised.
The default setting is 00 minutes (i.e. no delay), but can be set in 1 minute
increments up to a maximum 10 minutes.
A conrmation screen will be displayed to validate the settings. The Inspection
Delay can only be set during the initial activation process.
WES3 Base Station | RAMTECHGLOBAL.COM/WES/