Ramtech WES3 - Page 5

5
STEP 4 Pre-alarm function
The Pre Alarm function denes site-wide behaviour of the network during an
Inspection Delay period.
With Pre Alarm mode enabled, the entire network will emit a site-wide,
intermittent sound and (on strobe-equipped call points) an intermittent ash.
With Pre Alarm mode disabled, only the local call point which has been
triggered will sound. All other call points around site will remain in non-alarm
mode.
Pre Alarm can only be set during the initial activation process. Once set, the
Pre Alarm can only be changed by turning o and reactivating the WES3 Base
Station.
On completion of initial set up, settings for Inspection Delay and Pre Alarm
mode are displayed on the Base Station home screen.
Check the settings displayed on screen are the desired settings, and if not,
repeat the Initial Setup process before proceeding. The display is shown for the
WES3 Base Station is shown below.
WES3 Base Station | RAMTECHGLOBAL.COM/WES/
Base Station Display