7
4
ADD UNITS TO AN EXISTING SITE GROUP
Repeat sections 2 and 3.
5
POSITION UNITS
Once activated and paired, WES3 units can be installed on site. Ensure any
applicable local guidelines or standards regarding locating units on site are adhered
to, such as BS 5839-1 in the UK.
Wherever possible, avoid positioning the unit directly adjacent to metal frames,
electric cables and similar equipment that may interfere with the signal strength.
6
SECURELY FIX THE UNITS IN PLACE
Each WES3 unit must be securely xed in place and the tamper switch on the rear of
the unit must be in contact with the wall or ceiling.
Detector units are ceiling mounted and intended for indoor use only. Ensure a risk
assessment has been carried out and all reasonable safety precautions are in place
before commencing work.
Call Points must be securely xed, with the antenna upright, to a robust vertical
surface such as a wall or trolley. Where the existing surface is unsuitable for direct
xing, use backing board such as plywood or similar sheet material.
Each unit should be securely mounted using its two integrated mounting points
with M4 x 50mm pan head screws and wall plugs or other xings selected for the
particular wall or ceiling type.
WES3 Base Station | RAMTECHGLOBAL.COM/WES/
To Next Page
Loading...
