For more information on System Test, refer to the full WES3
User Guide and Operation Manual available in the VIP area of
ramtechglobal.com.
Note: Following initial installation, wait for a minimum of 60
minutes before starting the rst system test. During this time,
the WES3 units will self-calibrate to adjust for background radio
noise which may impact the accuracy of the system test.
Note: Powering o the WES3 Base Station unit will reset the
entire system as a ‘factory reset’, so avoid powering o
unless necessary.
8
WES3 Base Station
RAMTECHGLOBAL.COM/WES/
To Next Page
Loading...
