43
4. PROGRAMMING
Programming is carried out on two levels, namely:
“Bartender” programming
“Technician” programming
4.1 The “Bartender” Menu
When the “+” and “ – “buttons are pressed for appro-
ximately 2 seconds, the “bartender” programming
menu is activated. This menu contains the following
submenus:
To move from one submenu to another, press “+” or
“-”. To enter in a submenu, press “enter”, while to
quit, press “esc”.
When you enter a submenu, the display flashes the
editable value. To make changes, use the “+” or “-”
buttons.
If you make changes, these must be confirmed by
pressing “enter” until you quit the submenu. If you do
not wish to save your changes, press “esc”.
SELEZIONE
LINGUA
RESET
RIGENER.
RESINE
BEEP
SUI TASTI
OROLOGIO
SET TIMER
CONTATORI
PARZIALI
4.1.1 Selecting the Display Language
This menu allows you to select the language to be
used to show and messages on the display. You can
select among the following languages:
Italian, English, Spanish, French, German and Por-
tuguese.
RESET
RIGENER.
RESINE
BEEP
SUI TASTI
OROLOGIO
SET TIMER
CONTATORI
PARZIALI
ITALIANO
FRANCAIS
ENGLISH
DEUTSCH
ESPANOL
PORTUGUES
SELEZIONE
LINGUA
- Language selection
- Softener regeneration
- Beep
- Clock
- Set clock
- Date-time format
- Set timer
- Automatic switching ON
- Selection counts
- Coffee group 1
- Coffee group 2
- Coffee group 3
- Coffee group 4
- Water group
- TSC group
- Counter total
- Reset counters
SELECTION
LANGUAGE
REGENERATION
RESET
BEEP
CLOCK
SET TIMER
COUNTER
SELECTIO
N
SELECTION
LANGUAGE
REGENERATION
RESET
BEEP
CLOCK
SET TIMER
COUNTER
SELECTIO
N
ITALIANO
FRANCAIS
ENGLISH
DEUTSCH
ESPANOL