Need help?Do you have a question about the R&S EB500 and is the answer not in the manual?
General| Sensitivity | -165 dBm (1 Hz bandwidth) |
|---|---|
| Dynamic Range | > 75 dB (TOI) |
| Bandwidth | Up to 40 MHz |
| Input Impedance | 50 Ω |
| Power Supply | 100 to 240 V AC |
| Real-time Bandwidth | 40 MHz |
| Interface | LAN, USB |
| Frequency Range | 9 kHz to 6 GHz |
| Phase Noise | -100 dBc/Hz at 10 kHz offset |
Follow basic safety instructions for setup and connection to prevent injury or damage.
Basic steps for setting up the R&S EB500 for the first time.
Instructions for connecting the unit to a power source, including DC operation.
Describes the location of the DC power connection and standby power states.
How to connect mice, keyboards, and set up LAN connections.
Overview of the front panel elements of the EB500.
Explanation of the various inputs and outputs on the rear panel.
Description of the graphical user interface and its elements.
Overview of additional features and upgrades available for the EB500.
Instructions for cleaning the exterior of the R&S EB500.
Guidelines for storing and packing the R&S EB500 for transport or long periods.
Information on voltage and temperature checks at module test points.
Key sequence to retrieve the various firmware and GUI revisions of the R&S EB500.
Procedure for updating receiver firmware and GUI software for models with a front panel.
Method for updating receiver firmware for models without a front panel using Update32 tool.
Installing the Remote GUI for use on a notebook or desktop PC.
Procedures for changing the IP address of the R&S EB500.
To Next Page
