Software and Firmware Update
R&S
®
EB500
68Getting Started 4072.8432.02 ─ 04
4.5 Changing the IP Address
4.5.1 Using Update32 Tool
The IP address of the R&S EB500 can be changed using the "Update32" tool. By
default, the R&S EB500 is shipped with DHCP enabled.
Refer to "Retrieve Update32" under chapter 4.3, "Receiver Firmware Update for
EB500 without front control panel", on page 56 to read the steps for retrieving and
running the "Update32" tool.
Starting the procedure
Run Update32 and allow access if there are security warnings. If a configuration
is not loaded previously, refer to "Selecting the configuration file" under "Selecting
the configuration file"
on page 59 to select an appropriate configuration file. Select
"Config” -> “LAN Settings via Ethernet" as shown below:
Selecting the target R&S EB500
The
R&S EB500, for which you want to update the IP address, needs to be switched
on. Make sure there is a LAN connection between the R&S EB500 and the PC. After
a short period, a new entry will be shown in the list of targets as shown in fig-
ure 4-2. Select the appropriate target and press the "Start" button.
Changing the IP address
Make the desired changes in the LAN settings dialog as shown below. Select
“DHCP” if the R&S EB500 is to be connected to a DHCP server.
Changing the IP Address
To Next Page
Loading...
