Software and Firmware Update
R&S
®
EB500
61Getting Started 4072.8432.02 ─ 04
● Switch ON the power to the R&S EB500 ("target") to be updated. After a short
period a new entry will be shown in the list of targets as shown in figure below.
Fig. 4-2: List of targets for Ethernet Communication
●
Select the desired target and click the
"Start" button.
Updating process
The following dialog appears when the update starts. In the process, the flash is
being erased and then the new firmware is loaded into the flash.
Receiver Firmware Update for EB500 without front control panel
To Next Page
Loading...
