R&S EB500 - Options for the R&S EB500

Operation
R&S
®
EB500
36Getting Started 4072.8432.02 ─ 04
After browsing through the content by using the "Next
Link" you can
always go back to any of the previous pages by pressing the
"Back" key.
2.4
Options for the R&S EB500
In the R&S EB500, additional features can be enabled by using options and
upgrades. Options can be purchased together with the R&S EB500 or at any time
after that. Apart from options there are also upgrades. Currently there is only one
upgrade
available: the DF-upgrade: an existing R&S EB500 can be upgraded to get
the same features as a R&S DDF205. A brief description of the available options
and upgrades are listed below.
2.4.1
Panorama Scan ( R&S EB500-PS)
The R&S EB500-PS "Panorama Scan (PSCAN)" function is used to perform an
ultra-quick
scan of a user-definable frequency range. It thus provides a quick over-
view of the spectrum occupancy. Changes caused by illegal radio services, inter-
ferences, transient emissions etc. can immediately be seen at a glance. The
R&S EB500 can be switched to "listen" mode simply by pressing a key. The signal
of interest can be selected, demodulated and analyzed by using the demodulation
frequency.
Refer to the operating manual for a detailed explanation.
2.4.2
ITU Measurement ( R&S EB500-IM)
With SW option R&S EB500-IM (ITU-Measurement) installed, the measurement
functions "AM modulation index", "FM frequency deviation", "PM phase deviation"
and "bandwidth measurement" are available in addition to level and offset mea-
surement.
Refer to the operating manual for a detailed explanation.
Options for the R&S EB500