R&S EB500 - Page 67

Software and Firmware Update
R&S
®
EB500
67Getting Started 4072.8432.02 ─ 04
Click OK to install the "Redistributable" package. Installation will take a few minutes.
Start the Remote Access GUI via "Start" ->
"Programs" -> " R&S EB500 GUI". The
following dialog may appear due to the Windows Firewall. Click on "Unblock" to
allow the traffic to/from the R&S EB500
As a last step, you may have to change the Windows Firewall settings to enable the
network traffic of the R&S EB500 GUI. For this reason, start the GUI via "Start" ->
"Programs" -> " R&S EB500 GUI". When the GUI is displayed, the following dialog
may also appear.
Click "Unblock"
and the Windows Firewall is set to enable the network traffic of the
R&S EB500 GUI.
GUI Installation for Remote Access