R&S EB500 - Page 20

Operation
R&S
®
EB500
20Getting Started 4072.8432.02 ─ 04
In the table below follows the description of the different panels, according to the
panel number indicated in the figure above.
Panel
No.
Description
1 Basic receiver parameters
2 Icons
Shows
one or several of the following icons to indicate a specific function or condition of
the R&S EB500:
Compass connected.
GPS connected.
Configuration: using external reference.
Receiver overflow.
Recording in progress.
Marker selected.
Speaker is off.
Speaker is on.
Audio signal is available in stereo at current frequency.
The R&S EB500 is not locked.
The R&S EB500 is locked by another client. Access is not possible.
The R&S EB500 is locked. Only the current operator can make changes
(exclusive write access).
A critical error occurred in the receiver. The "Test Points"
dialog will provide
more information.
3 Mode
Shows the current receiver mode, e.g. FFM, PScan, FScan or MScan. The current date
and time is also shown.
4 Frequency
Shows the current receiver frequency. As this is the most important parameter, it is dis-
played much larger than the remaining parameters.
Graphical User Interface (GUI)