R&S EB500 - Page 31

Operation
R&S
®
EB500
31Getting Started 4072.8432.02 ─ 04
2. Select the "SCAN" softkey and select "FSCAN". The panel layout will change
so
that a RF panorama is included. The softkeys in the Mode Menu will change
according to the scan type selected. The mode is also displayed below the cur-
rent date & time.
3. Press the ESC key to go back to the top menu. Ensure panel focus on the RF
Panel. Use the PANEL key to change if required. The softkey menu will be
available for the RF Panel and the Frequency Scan function.
4. Use "START", "STOP" and "STEP" or "CENTER", "SPAN" and "STEP" softkeys
to define the range and frequency step of the scan. In this example, start and
stop frequencies are set to 20 MHz and 200 MHz, respectively, with a step of
100 kHz.
5. The time it takes to acquire a frequency point is determined by the "Dwell
Time", "No Signal Time" and "Measurement Time" settings. For details refer to
the Operating Manual.
6. The "CONFIG RF PAN" softkey can be used to set the scale as per the "IF Panel
Config" softkey in chapter 2.3.2.5, "Basic Operation - Fixed Frequency Mode
(FFM)", on page 24.
7. Press the MODE key again to open the Mode Menu.
8. Select
the "Run +" softkey to start the frequency scan. The Mode display below
the date and time will change from "FScan Stop" to "FScan" to show that FScan
is running.
Graphical User Interface (GUI)