Fig.7-12
Final Checks
Hob Check
Check each cooking zone in turn. Be sure to use pans of the
correct size and material.
Grill Check
Turn on the grill control and check that the grill heats up.
Oven Check
Turn on the oven. Check the oven fans start to turn and that
the oven heats up.
Final Fitting
Fitting the Handrail
Using the 2 mm Allen key supplied, loosen the 2 retaining
screws in the base and side of the handrail support. Fit the
handrail support onto the locating bosses on the fascia
(Fig.7-10).
Note: The handle support should face upwards.
Push the support back against the fascia and tighten the
2retaining screws. Repeat for the other side. Check that each
support is secure.
Locate the handrail onto the support tabs and, using the
2.5 mm Allen key supplied, tighten the 2 retaining screws in
the bottom to secure (Fig.7-11).
Fitting the Plinth
Remove the 3 screws for the plinth mounts along the front
bottom edge of the cooker (Fig.7-12). Fasten the plinth using
these screws.
Customer Care
Installer: Please complete your details in this guide, inform
the user how to operate the cooker and hand over the
instructions.
Thank you.
Fig.7-10
Fig.7-11
Retaining
screw
To Next Page
Loading...
