Rapid Engineering BH-40 - Page 5

TABLE OF FIGURES
Figure 1: Top and Bottom Panel Label Placement .................... 2
Figure 2: Side and Back Panel Label Placement......................3
Figure 3: Standard Reflector .....................................................6
Figure 4: One Side Reflector..................................................... 6
Figure 5: Two Side Reflectors ...................................................6
Figure 6: 45° Tilt Reflector ........................................................7
Figure 7: U-Tube, Standard Reflector........................................7
Figure 8: U-Tube, 45°................................................................ 7
Figure 9: U-Tube, Opposite 45° Reflector ................................. 8
Figure 10: 2-Foot Deco Grille and Protective Grille ...................8
Figure 11: Lower Clearance Shield ...........................................8
Figure 12: Venting ..................................................................... 9
Figure 13: Major Component Descriptions.............................. 11
Figure 14: Critical Hanger Placement ..................................... 15
Figure 15: Linear Heater Assembly Overview ........................ 16
Figure 16: Linear Heater Layout Overview ............................. 17
Figure 17: Linear Heater Layout Overview (Continued) .......... 18
Figu
re 18: U-Tube Heater Assembly Overview ...................... 26
Figure 19: U-Tube Heater Layout Overview ........................... 27
Figure 20: U-Tube Layout Overview (Continued) .................... 28
Figure 21: Reflector Joint Detail ..............................................30
Figure 22: Tube Termination ...................................................36
Figure 23: Gas Connection with Flexible Gas Hose................42
LIST OF TABLES
Table 1: Contents of BH-Series Burner Carton.......................12
Table 2: Contents of Core and Extension Packages .............. 12
Table 3: BH-Series Component Package Guide ....................13